Linux ip-adresse ändern ifconfig

Startseite / Technologie & Digitales / Linux ip-adresse ändern ifconfig

Der Befehl ifconfig muss beim Systemstart verwendet werden, um die Netzadresse jeder auf dem System vorhandenen Schnittstelle zu definieren. 1 Dieser Artikel beschreibt wie man den ifconfig Befehl benutzen kann, um Informationen über Netzwerkschnittstellen anzuzeigen und zu verändern. 2 In diesem Artikel wird erklärt, wie Sie die IP-Adresse eines Servers ändern, oder eine weitere, zusätzliche IP-Adresse hinzufügen. Per default sind die. 3 Um zu beginnen, geben Sie an der Terminal-Eingabeaufforderung ifconfig ein und drücken Sie die Eingabetaste. Dieser Befehl listet alle Netzwerkschnittstellen. 4 To change your IP address on Linux, use the “ifconfig” command followed by the name of your network interface and the new IP address to be changed on your computer. To assign the subnet mask, you can either add a “netmask” clause followed by the subnet mask or use the CIDR notation directly. 5 ifconfig (interface configuration) is a network management tool. It is used to configure and view the status of the network interfaces in Linux operating systems. With ifconfig, you can assign IP addresses, enable or disable interfaces, manage ARP cache, routes, and more. 6 To get started, type ifconfig at the terminal prompt, and then hit Enter. This command lists all network interfaces on the system, so take note of the name of the interface for which you want to change the IP address. To change the settings, you also use the ifconfig command, this time with a few additional parameters. 7 For setting an IP address, use it like this: ip addr add [ip_address] dev [interface] For example, add an IP address to the eth1 interface as: sudo ip addr add /24 dev eth1. You now have two IP addresses: one from the old configuration and one from the new command: Changing IP address in Linux. 8 The procedure to change IP address in Linux is as follows: Open the terminal application. List the current IP addresses for all network interfaces with command ifconfig -a; Take the network interface down with command: ifconfig down; Change the IP address with command ifconfig ip address> Press Enter to run. 9 To change the settings, you also use the ifconfig command, this time with a few additional parameters. The following command changes the network interface named “eth0” to use the IP address , and assigns the subnet mask sudo ifconfig eth0 netmask You could, of course, substitute in. linux ip-adresse anzeigen 10 Bei dem Einsatz eines DHCP-Dienstes sollte das Setzen einer festen IP-Adresse auf Seite des Clients nur dann erfolgen, wenn Adresskonflikte mit den übrigen. 11